Auto darkening welding helmets have proven to be an indispensable device when it comes to effective and safe welding. However, controlling and adjusting this piece of equipment can take up time and effort if you are not familiar with it. Here are the tips on how to adjust auto darkening welding helmet that you, my fellow welders, need to learn.
Table of Contents
How To Adjust Auto Darkening Welding Helmet?
The ON/OFF button is not available on this kind of welding helmet due to ADF’s utilization (Auto Darkening Filter). Once the helmet is put in use, the sensor from this filter automatically works. The lens’ shade will change according to any light source from the arc coming out, which allows you to proceed with the welding action without any problem.
Most of the welding helmets are not required to be switched off manually once the sensor no longer detects any light impact after 15-20 minutes for safety purposes.
Sensitivity Controls
Welding comes in various forms, which requires the darkening helmet’s filter to fit in with the need for diverse light responsiveness. In most of the welding forms, a mid-level affectability will produce the welding effect you are looking for. Before starting welding, ensure the sensitivity measurements are about half of the measurement.
If you want to make changes to the sensitivity control, remember to follow these steps. First up, bring the helmet to its original state. Once the helmet is shut down by pressing the reset button, you can start to alter the sensitivity level based on your project’s requirement.
From that point onward, confront your head protector with the light-bearing and begin switching the affectability control up to test which sensitivity level is a match. Continue switching the control until you find the lens clear. On the off chance that you notice flashes, switching the sensitivity levels button to a higher level for later improved outcomes.
Reset Button
The reset button should be used whenever you want to test the helmet’s efficiency level.
Bear in mind that you cannot press this resetting button when the helmet is switched on. This act will automatically shut down the ADF, which can damage the helmet in operation.
With the helmet resetted, the lens will be programmed back to a two-times-darker mode, followed by the transparent mode. However, if your helmet does not experience the same effects, maybe it has been malfunctioned and needs an overall analysis.
An auto darkening welding helmet
Grind Mode
Grind mode is the selection you cannot use during welding because this activation will not only darken the filter but also expose your vision to the arc light, which can pose a serious threat to your eyesight. In case you want to turn on this grind mode, alter the sensitivity switch which is on the the right of the control system.
Frequently Asked Questions
Q: How do you automatically activate an auto darkening welding helmet?
A: The answer goes to the lens of your helmet. In case your helmet is in the best shape, its lens will have no trouble in automatically darken to fit in with the arc light coming out.
Q: Is auto darkening welding helmet safe?
A: When the ark is started, the sensors on the cap obscure the focal point to shade #9 to #13 rely on the setting. Before you can even close your eyes, this change has already happened. Your eyes will be shielded from all the harmful beams.
Conclusion
And that’s the settings you need to know on how to adjust auto darkening welding helmet.
Accordingly, you just ought to experience the client manual given by the manufacturer and understand everything about this head protector’s usefulness. You will soon realize that this procedure is simple, essential, and quick once you have every welding detail under control.
Happy welding!